Expansion Parts | How to Install (Video)

Here's how to install the Biorium extension parts, shown in a video.

Gap Guard

Insert and attach this product into the gap of the automatic feeder.

Silent Flow Guide

Float the pump unit about 5mm and attach it to the drain.

Flexible Ventilation Support

1. Remove the aquarium lid once.
2. Insert the gap part of this product into the thickness of the aquarium glass.
3. While inserted, push it towards the back of the aquarium and firmly fix the protruding part with a click.
4. Install the lid so that it covers the top of this product.

Water Change Assist

1. Insert the two included tubes into the attachment ports.
2. Cut one of the tubes with scissors.
3. Put the water for the aquarium into a plastic bottle.
4. Attach this product and the plastic bottle as if closing a cap.
5. Attach the recess of this product to the thick plate of the aquarium.

Cooling Fan

1. Attach the magnetic base to the gap of the automatic feeder with double-sided tape.
2. Press firmly.
3. Place the cooling fan body on top.

Soil Protector

1. Remove the sand guard plate at the aquarium's water inlet.
2. Attach it to the water inlet with the vent facing upwards.
Please note that this is a tight fit and requires some technique.

Aeration Set

1. Choose your preferred airstone: block type (small) or plate type (large).
2. Insert the included tube onto the switch's protrusion.
3. Fix the included suction cup to the wall and clip the switch into the lid's notch.

Food Dryer Attachment

1. Place desiccant inside the food dryer attachment.
2. Insert it into the protrusion at the bottom of the automatic feeder.

Fry Suction Guard

1. Please confirm there are a total of 6 parts. Assembled, they form 2 attachments.
2. Fit the mesh into the thick black frame, then overlay the thin frame. Do this for two sizes.
3. The smaller part is for the upper water inlet, and the larger part is for the lower water inlet. Remove the sand guard plate from the lower water inlet.
4. Fit the left and right protrusions of the part into the slits at both ends of the water inlet.